Using one or two turnables under CLIO’s control and automation it is possibile to easily collect sets of loudspeaker (complete or partial) impulse responses balloons.
The Autosave control panel allows for a simple setup of the measurement set, then CLIO
manage the whole process:
- send positioning commands to the turntables and monitor their status
- perform MLS/Log Chirp measurements and save the results with the naming rules
Read more...

Read the Seminar "Automated Loudspeaker Balloon Measurement" held at April 2009 ALMA European Symposium.

CLIO supports the Outline ET250-3D (Ethernet) and LinearX LT-360 (Serial and USB). The collected measurement sets can be viewed as a 3D balloon:

A powerful tool exports the measured data towards the most common simulation software formats.
The supported export format are:
-EASE .xhn
EASE .xhn ASCII format (only module, no complex data).

-CLF v2 .tab
Common Loudspeaker Format CLF v2 .tab ASCII format.

-Impulse Responses
Set of Impulse Responses in ASCII .txt format ready to be imported with EASE SpeakerLab.